Striped One Piece Swimsuit

Colour: Black with White Piping

4.0 from 3,569 ratings

We built this swimsuit around built-in molded cups that hold their shape in the water. The black base is framed by crisp white piping to create clean vertical lines across the torso. Wide fixed straps distribute bust weight across your shoulders without cutting in.

$29.99

Also cut in 5 other colours

How this one is put together

Molded inner cups
We set smooth molded cups inside the bust to give round definition and support without underwires. They keep their shape when wet and prevent show-through after swimming.
Wide shoulder straps
The shoulder straps are cut wide to sit flat against the collarbone. They do not roll or dig into the skin when supporting a fuller bust in the water.
Front stripe pattern
White piping and directional stripes break up the solid black front panel. The placement draws the eye inward and gives a smooth line along the waist and ribcage.
Full seat coverage
We cut the leg openings for moderate height and reliable rear coverage. The stretchy knit fabric stays put as you move and dries quickly once you step out.

Getting the size right

Take a snug under bust measurement on a full exhale, then an over bust measurement with the tape resting. The gap between the two sets your cup letter.

Open the fit finder

Sister sizing works here too: if the band is tight, move up a band and down a cup. How that works.

Sizing

This one runs on standard apparel sizing rather than band and cup, so it sits outside the fit finder. The listing carries the measurement table we sew to.